Assembly - Progear Fitness Air Elliptical Owner's Manual

Progear fitness air elliptical owner's manual
Table of Contents

Advertisement

56 56
55 55
A
52 52
93 93
52 52
1. Front/Rear Stabilizers and Adjustable Levelers Installation:
Step A: Align the Front Stabilizer (54) onto the front curve of the Mainframe (59).
Make sure the arrow is pointing UP on the front stabilizer and that the Transport
Wheels (93) position toward the front and parallel off the floor. Attach two Bolts (52)
and on the other ends of bolts with two Curve Washers (55) and two Cap Nuts (56).
Using the flat wrench, tighten the cap nuts until firm.
Step B: Align and attach the Rear Stabilizer (62) onto the rear curve of the Mainframe
(59) with two Bolts (52) and the other ends with two Curve Washers (55) and two Cap
Nuts (56). Using the flat wrench, tighten the cap nuts until firm.
Step C: Remove the Nut (58) from the Adjustable Leveler (57). Screw the levelers
onto the bottom of the Mainframe (59) and hand-tighten the nut to the leveler.
Repeat for the other side. Note: Finish assembling the elliptical first and then refer to
page 20 on adjusting the levelers as needed.
IMPORTANT: To prevent Elliptical from wobbling, make sure you adjust the
levelers as instructed on Page 20.
Hardware:
Front Stabilizer
Hardware (Step A)
Rear Stabilizer
Hardware (Step B)
(52) Bolt
(55) Curve Washer
(56) Cap Nut

ASSEMBLY

59 59
58 58
56 56
56 56
57 57
55 55
C
54
54
4 PCS
4 PCS
4 PCS
B
52 52
52 52
62 62
Tool:
55 55
Open-Ended Flat Wrench
(Step C)
(57) Adjustable Leveler
(58) Bolt
9
2 PCS
2 PCS

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents