4-3 Back Space Editing
You can record multiple scenes as a single sequence
with no noise or breakup between scenes (back space
editing).
Proceed as follows.
TC
00 : 00 : 00 : 00
AU-1
AUTO
1
Carry out step 1 in the section 4-1-2 " Recording
Operation" on the previous page to start recording
a scene.
2
When recording finishes, press the PAUSE button.
The tape is rewound to a point 3 seconds before
you pressed the PAUSE button, and the unit enters
recording pause mode.
Note
When recording is paused, do not do any of the
following. Back space editing will be interrupted.
• Eject a cassette
• Play back, rewind, or fast forward the tape
• Press the STOP button
525 SX-- BATT
VITCON
SDI
5
2,3,4
3
At the next scene, press the PAUSE button.
The tape moves to the recording start position and
recording starts.
4
Repeat steps 2 and 3 to record more scenes.
5
When you are finished recording scenes, press the
STOP button.
To record continuous timecode
Set item 610 in the Setup menu to a setting other than
MANU (see page 6-15).
Chapter 4 Recording and Playback
4-3