Making Settings In The Video Settings Pages - Sony Betacam SX DNW-A28 Operation Manual

Input and Output Settings for Video and Audio Signals (Submenu)
2-8-3 Making Settings in the
Video Settings Pages
The following tables show the items that can be set in
the video settings pages.
Video settings page 1/2
VIDEO CONFI
VIDEO
80
PRESET
Item Setting
VIN TRIG
Select whether or not to output a GPI signal
from pin 5 of the AUX connector at the IN
points of a video auto-edit (excluding audio
split editing).
OFF: Do not output a GPI signal.
ON: Output a GPI signal.
CONFI Select whether or not to carry out CONFI
playback during crash recording.
OFF: No CONFI playback
ON: CONFI playback
Note
In insert or assemble editing, CONFI
playback is not possible.
Select whether or not to carry out preread
PREREAD
editing.
OFF: No preread editing
ON: preread editing
Set the input level of composite video input
VIDEO IN
signals.
PRESET: Fixed at factory default level.
VAR: Adjustable as desired.
To adjust
The current input level is displayed when you
select VAR. Press the MARK/UP or LIST/
DOWN button to change the displayed value.
Adjust so that the input video level display
bar is close to the center.
OUT REF Select the signal to which the internal
(See page reference video signal generator is
2-7 for synchronized.
details.)
REF: Synchronize with the signal input to the
REF. INPUT connector.
INPUT: Synchronize with the signal selected
in the home page (composite video signal
or SDI signal).
2-22
Chapter 2 Preparations
PREREAD VIN TRIG
OUT REF
INPUT
Video settings page 2/2
AUD SG
SILNC
Y/C DLY
PROCESS
CONTROL 800
PRESET
PANEL
a) For 525 mode, CB100 for 625 mode.
Item Setting
PROCESS Select SETUP when you want to adjust the
CONTROL following items with the setup menu, and
PANEL when you want to adjust them with
the submenus and the lower control panel.
• Output video level
• Chroma output level
• Setup level (525/60 mode)
• Black level (625/50 mode)
• Chroma phase
• Y/C delay
• Sync/subcarrier phase
Y/C DELAY When the "PROCESS CONTROL" is set to
PANEL, set the Y/C delay value.
PRESET: Fixed at factory default level.
VAR: Adjustable as desired.
To adjust
Press operation button F4 to indicate the
VAR, press F4 again to highlight the value,
and then press the MARK/UP or LIST/DOWN
button to change the value.
SYNC PH When the "PROCESS CONTROL" is set to
PANEL, adjust the sync phase by pressing
the MARK/UP or LIST/DOWN button.
SC PH When the "PROCESS CONTROL" is set to
PANEL, adjust the subcarrier phase by
pressing the MARK/UP or LIST/DOWN
button. The SC-H value is constant.
SG Select the output of the internal audio or
video signal generator for the source signal.
OFF: Neither of the output of the internal
audio nor video signal generator
AUDIO: The output of the internal audio
signal generator
VIDEO : The output of the internal video
signal generator
BOTH: Both of the output of the internal
audio and video signal generators
AUD SG
Select the operation of the internal audio test
signal generator.
SILNC: Silent signal.
1kHz : At 1 kHz, –20 dB FS sine wave is
supplied to all audio input channels.
ID: Signal for recognizing each channel.
VID SG SG
a)
CB75 OFF
SYNC PH SC PH
80 200