Table of Contents
Advertisement
Editing
One button dubbing
Video8=> <=VHS
One button dubbing is a way of editing
the entire tape contents to another tape
automatically from one deck to the
other.
as
aa
EOSsS|,
= GaEfeo DONG ace = |
* Turn on your TV and set it to the
video channel.
DUBBING
= SP/LP
1
Insert a source tape into one deck and a tape for recording into the
other deck.
2
Press Video8 => or += VHS to select the editing direction.
"Video8 => " means that the recording is made from the 8 mm tape to
the VHS tape.
"<= VHS" means that the recording is made from the VHS to the 8 mm
tape.
The VCR rewinds both tapes to the beginning, and starts dubbing
automatically. When either tape reaches the end, the VCR rewinds both
tapes to the beginning, and ejects them. And then, the power turns off
automatically.
To stop editing
Press the & STOP button.
Notes
« When editing from VHS tape to 8 mm tape, note the following:
- If editing is proceeding with a VHS tape that you have recorded, the tape may be
automatically ejected. In this case, check the safety tab. If the tab is removed,
cover the tab hole with adhesive tape and after recording, remove the tape to
protect the recording. Make sure of the direction for recording so that you won't
accidentally erase an important recording.
- If the safety switch on the 8 mm tape to be used as an original tape is slid out so
that the red portion is visible, the tape is automatically ejected. In this case, slide
the switch back in place so that the red portion is not visible. Make sure of the
direction for recording.
* Noise may appear at the beginning part of the edited tape.
* If the playback deck play blank for 5 minutes, both decks automatically stop,
rewind tapes to the beginning, and eject them. And then, the power turns off
automatically.
52 | Editing
Advertisement
Table of Contents
