Advertisement
Sync proceedure:
For synchronization the CI-V router does NOT have to be operational. It should be cabled up, but
power on the computer and CI-V router should be off.
Make sure all radios are configured to the same baud rate (9600) and CI-V Transceive is set to
"ON".
It is wise to ALWAYS reset the PW-1 microprocessor before beginning the synchronization
operation. This will put the PW-1 into a known state, waiting for for synchronization. This
proceedure is on page 11 of the PW-1 manual.
Turn off everything. There should be NO LEDs or lights on within the PW-1.
While holding down the "UP" and "DOWN" buttons at the same time, turn on the power to
the PW-1.
The microprocessor is now reset.
Turn off the power to the PW-1.
One radio proceedure:
Turn off everything. There should be NO LEDs or lights on within the PW-1.
On the back of the PW-1 make sure the "EXCITER" switch is in the "1" position.
While holding down the "INPUT" buttons turn on the power to the PW-1.
The Input 1 light will now be blinking.
Turn on the transceiver and wait for it to boot.
Turn the frequency knob until the INPUT 1 lamp on the PW-1 stops flashing.
Turn off the PW-1
Turn off the radio
Synchronization is complete.
Turn on the PW-1
Turn on the radio.
The "AUTO" light should be on.... if not hit the "DOWN" button until the "AUTO" light is
on. You are now in sync.
Two Icom radio proceedure:
Turn off everything. There should be NO LEDs or lights on within the PW-1.
On the back of the PW-1 make sure the "EXCITER" switch is in the "1&2" position.
While holding down the "INPUT" buttons turn on the power to the PW-1.
The Input 1 light will now be blinking.
Push the "DOWN" button on the PW1. The band indicators 1.8 through 50 should light
continuously.
Turn on the transceiver #1 and wait for it to boot.
Turn the frequency knob until the INPUT 1 lamp on the PW-1 stops flashing.
Turn off the transceiver #1
Push the "INPUT" button and INPUT 2 lamp blinks.
Turn on the transceiver #2 and wait for it to boot.
Turn the frequency knob until the INPUT 2 lamp on the PW-1 stops flashing.
Turn off the transceiver #2
Turn off the PW-1
Synchronization is complete.
Page 28
Advertisement
