Advertisement
configuration you like, give it a name in the "Save Session" line and hit save.
NOTE: This configuration program ALWAYS runs at 115200 baud rate regardless of the
settings configured.
Pressing the reset button on the Arduino will bring up the following:
Note: These settings do not represent the default setting as shipped. The first line will tell
you the version and date of the current CI-V router software. The second line tells the
amount of free static RAM available for the program to use. The board has 8K bytes.
At this point the user can input either 1 through 13 followed by "ENTER".
Selecting either 1 or 2 brings up a second 'baud rate setting' menu, where the user can select the
desired baud rate. Or if 3 through 6 is selected the boolean can be toggeled between True and
False by selecting the parameter.
Transceive, default is true, is discussed later. It is best to leave at true for single radio operation.
USB Echo, default is true, and it causes any command sent from the computer to the USB port to be
echoed back. This is required for the program DX4WIN, and perhaps others. It does, slightly slow
down polling in other programs.
Subwitch, default is true, has the router running in a passive mode, where everything is routed.
Page 10
Advertisement
