Advertisement
RTS and DTR Enabled boxes MUST BE UNCHECKED! CAT speed must be set to the same speed
as the router Computer baud rate. TRX Port must be set to the COM port for the CI-V router.
TRX-Manager supports only COM 1 through 15, odd for a program that supports so many devices.
The Dual control, when checked causes TRX Manager to query the radio for many parameters,
when unchecked, it just listens to 'broadcast' messages from the radio.
Control must be between E0 and EF Hex, the default of E0 if fine.
The CI-V Router USB Echo can be either on or off.
All other settingscan be done per the manual, or users descretion.
With TRX-Manager with "Dual Control" selected, it is best to run the CIV baud rate and the
Computer baud rate as high best responsiveness.
TRX-Manager supports four transceivers, make sure you are setting up and observing the same
transceiver. Also make you reset the application after making ANY changes.
It is advised to run CI-V firmware 1.05 or greater with TRX-Manager.
LOGic9
I am not an expert on LOGic9, but I did go their website and downloaded the "Demo" version of the
program.
http://www.hosenose.com/LOGic/default.aspx
It is important to note that following configuration parameters must be set to TRUE for proper
operation with LOGic9:
Configuration is done by selecting on the meun, "Tools", then "Setup" and then "Misc ham setup,
Page 24
Advertisement
