Advertisement
However, when the PC controlling software switches to the sub VFO to check what frequency it is
on, then everything else (PW-1, antenna switches etc) will follow. If Subswitch is off, the
reported frequency will remain with the "main" VFO when the PC software commands a switch to
the sub VFO. This eliminates many unnecessary jumps, and it further supports SO2V operation,
however it does not support cross band split operation. This is an attempt to "fix" a short coming in
the Icom control interface. Try turning it off and see if you like the result.
Note: Free memory number shows the amount of unused RAM in bytes in the Atmel processor.
This number will vary with different releases of software. There is 8 * 1024 bytes of RAM
available.
The computer baud rate is the baud rate at which the CI-V Router communicates with the host
computer via the USB. The value should be the highest baud rate supported by all of your PC
logging and contest programs. The default is 38400, which is supported by many programs.
The baud rate for the CI-V bus is the baud rate for each of the three CI-V ports. If using a Icom
PW-1 amplifier Icom recommends a baud rate of 9600. If your radio support "auto", baud rate, do
not run operate the radio in the "auto" mode, specify the baud rate.
Config CI-V Router
1 -Computer baud rate = 38400
2 -CI-V baud rate = 9600
3 -Transceive msg to other radios = True
4 -Transceive msg to USB = True
5 -USB Echo = True
6 -Subswitch = True
7 -Split OFF when QSY >1MHz = False
8 -Enable driver power level = False
9 -Enable driver power level learn = False
10-Small power table = False
11-Driver power table
12-Icom radio CI-V address 0x64 hex
13-Reset all to default values
Which parameter to change? 1
1
Select baud rate:
1- 300
2- 1200
3- 2400
4- 4800
5- 9600
6- 14400
7- 19200
8- 28800
9- 38400
10- 57600
11- 115200
Which baud rate 1..11? 10
Config CI-V Router
1 -Computer baud rate = 57600
2 -CI-V baud rate = 9600
3 -Transceive msg to other radios = True
4 -Transceive msg to USB = True
5 -USB Echo = True
6 -Subswitch = True
7 -Split OFF when QSY >1MHz = False
8 -Enable driver power level = False
9 -Enable driver power level learn = False
Page 11
Advertisement
