Safety Instructions - SAGEMCOM D680C Solo User Manual

Recommendations and

safety instructions

For safety reasons, never put the handset in the base station
without the battery inserted or without the lid on the battery
compartment as this could cause an electric shock.
To avoid damaging your handset/base, only use certified
rechargeable batteries NiMH 1.2 V 750 mAh, never use non
rechargeable
handset/base battery compartment respecting polarity, do not
dispose of batteries in fire, they may explode, if the handset
will not be used for an extended period of time, unplug the
battery and remove it from the handset to prevent possible
leakage, keep batteries out of the reach of children
Only use the power unit supplied and connect it to the
electricity
instructions in this user manual and the details on the sticker
regarding voltage, electrical current and frequency. As a
precaution if there is a risk of danger, the power plug can be
pulled out to disconnect the 120V power supply. Therefore the
sockets should be near the device and easily accessible.
Do not install your DECT telephone D680C in a humid
environment, such as a bathroom, washroom, kitchen etc, and
not within 5 feet of a source of water or outside. Never touch
the electrical connection with wet hands. Do not allow liquids
to enter into the device. Switch off the device and disconnect
it from the power supply if liquids or foreign substances end
up inside the device. This device is designed for use in
temperatures of between 41 ºF and 104ºF . Do not expose the
product to extreme temperatures such as areas near a hot
radiator, stove or in a hot car.
batteries. Insert
mains in accordance
2
the batteries
with the installation
in the