Brother 888-G00 Operation Manual page 113

d Position the fabric so that the needle is 2 mm (1/16
inch) in front of the area to be darned.
1
2
1 Tear
2 2 mm (1/16 inch)
Pass the upper thread down through the hole in the
presser foot, and then lower the presser foot.
• When lowering the presser foot, do not push in the
front of the presser foot, otherwise the darning will
not be sewn with the correct size.
1 Do not reduce the gap.
e Pull down the buttonhole lever as far as possible.
a
1 Buttonhole lever
The buttonhole lever is positioned behind the bracket
on the buttonhole foot.
1
2
1 Buttonhole lever
2 Bracket
f Gently hold the end of the upper thread in your left
hand, and then start sewing.
g
h
a
Reinforcement Stitching
Raise the presser foot lever, remove the fabric, and
then cut the threads.
Raise the buttonhole lever to its original position.
Memo
• If the fabric does not feed, for example, because it
is too thick, increase the stitch length. For details,
refer to "Setting the stitch length" in the "Basic
operations" section.
S
Sewing S-37