Advertisement
Mounting and wiring the camera prep bracket kit
Wiring:
For using your camera kit as a reversing camera system:
1. Isolate the 12V power system
2. To provide power to the wireless camera for use as a reversing camera,
run a 2 core 16AWG internal cable from your reversing (back up) light on
the rear of your trailer, truck or RV, or from your 7 way cable reversing
power supply.
(7way reversing connections.. center pin #7 positive + Ground pin #1 negative).
3. Connect the camera prep kit power cable to the reversing wire from
step 2.
Supplied 6 ft power cable for the camera:
Red = Positive
Black = Negative
4. Find a suitable position to mount your camera mounting bracket on the
rear of your trailer or RV. Make sure the mounting position is at the
center line of the RV and is positioned as high as possible.
Ensure the mounting surface is flat and has enough surface area for the
entire mounting bracket to fit.
5. Drill a 5/8" through hole on the rear of the trailer or RV in the position
where the camera is to be mounted. Use a grommit to protect cable.
6. Feed the power cable through the hole and gasket, before mounting the
camera bracket with 4 screws
Connection cable supplied with prep kit
Furrion camera
Use one of these power sources to supply 12V DC when the system is applied as a reversing camera
12V DC from 7 Way connection
12V DC from backup lamp
7
Hide quick links:
Advertisement
