Assemble Headlamp Strap; Usage And Maintenance - Fenix HL30 User Manual

Assemble Headlamp Strap

Headlamp strap without
pattern

Usage and Maintenance

Please do not disassemble the sealed head, doing so can cause damage to the light and will void the
warranty.
High-power light should use battery with high current discharge capability; we suggest using
high-performance Ni-MH rechargeable battery, using alkaline battery will decrease the runtime of this
high-intensity light.
Please use batteries of high quality, and take out the battery if you do not use the light for a long
time, or the light can be damaged by electrolyte leakage or battery explosion which is caused by low
quality battery.
The o-ring may be worn out after using for a long time. If it happens, please replace the o-ring with a
new one to keep the light properly sealed against water.
Please clean the contacts of your light from time to time, especially if the light flickers or doesn't
light up. There may be several reasons for a flickering or not working light:
Reason A: The batteries need replacing.
Solution: Replace the batteries (Please confirm the correct installation of anode and cathode).
Reason B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with an alcohol soaked cotton swab.
If the above methods don't work, please contact the distributors and refer to the warranty policy.
Headlamp strap with
pattern
Top headlamp strap
with pattern
The mount of the
top headlamp strap