Trial Period Precautions; Packing; Trouble - Orban OPTIMOD-FM 8200 Operating Manual

Manual
The Operating Manual contains instructions to verify the proper operation of this unit and initialization of certain options.
You will find these operations are most conveniently performed on the bench before you install the unit in the rack.
Please review the Manual, especially the installation section, before unpacking the unit.

Trial Period Precautions

If your unit has been provided on a trial basis:
You should observe the following precautions to avoid reconditioning charges in case you later wish to return the unit to
your dealer.
Note the packing technique and save all packing materials. It is not wise to ship in other than the factory carton. (Replace-
ments cost $35.00).
(1) Avoid scratching the paint or plating. Set the unit on soft, clean surfaces.
(2) Do not cut the grounding pin from the line cord.
(3) Use care and proper tools in removing and tightening screws to avoid burring the heads.
(4) Use the nylon-washered rack screws supplied, if possible, to avoid damaging the panel. Support the unit when
tightening the screws so that the threads do not scrape the paint inside the slotted holes.

Packing

When you pack the unit for shipping:
Tighten all screws on any barrier strip(s) so the screws do not fall out from vibration.
Wrap the unit in its original plastic bag to avoid abrading the paint.
Seal the inner and outer cartons with tape.
If you are returning the unit permanently (for credit), be sure to enclose:
• The Manual(s)
• The Registration Card
The Line Cord
•
All Miscellaneous Hardware (including the Rack Screws)
•
The Extender Card
•
• The COAX Connecting Cable
Your dealer may charge you for any missing items.
If you are returning a unit for repair, do not enclose any of the above items.
Further advice on proper packing and shipping is included in Section 5: Troubleshooting.

Trouble

If you have problems with installation or operation:
(1) Check everything you have done so far against the instructions in the Manual. The information contained therein is
based on our years of experience with OPTIMOD and broadcast stations.
(2) Check the other sections of the Manual (consult the Table of Contents and Index) to see if there might be some
suggestions regarding your problem.
(3) After reading the section on Factory Assistance, you may call Orban Customer Service for advice during normal
California business hours. The number is (1) 510/351-3500.
PLEASE READ THIS FIRST!
®