Ultrastable Pilot For The 8200 Stereo Encoder - Orban OPTIMOD-FM 8200 Operating Manual

Digital audio processor
Table of Contents

Advertisement

OPTIMOD-FM 8200
The correct peak level of the stereo program applied to the stereo encoder sometimes
depends on the number of subcarriers in use. Some regulatory authorities require that total
baseband modulation be maintained within specified limits. Thus the level of the stereo main
and subchannel must be reduced when a subcarrier is turned on.
The 8200's remote control feature allows you to reduce the stereo main and sub-channel
level by connecting an on/off signal from your subcarrier generator (See page 2-14). You
define the amount of reduction in % on the SYSTEM SETUP
page 2-60). See page 2-74 for information on programming the remote control.

Ultrastable Pilot for the 8200 Stereo Encoder

This section explains how the OPTIMOD 8200 Stereo Encoder Board can be modified to
generate a pilot with ultrastable frequency.
This modification will allow a station's carrier frequency to be maintained within 100Hz of
the assigned channel frequency when using the 8200's stereo pilot as a reference. With a
100MHz carrier, this requires a stability of 1 part per million (ppm). This stability can only
be realized with a Temperature Compensated Crystal Oscillator (TCXO).
The 8200 Stereo Encoder Board has four unused pads that are spaced for a certain TCXO
package to be soldered into place. Four components also have to be removed from the Stereo
Encoder Board to make room for the TCXO. They are R102, Y1, C40 and C41.
We have found three different TCXOs that can be used on the 8200 Stereo Encoder Board.
They are:
Manufacturer
Model
Monitor Products
7402 Series, Model B
Raltron
TF69100-4.864
RXD
621B
As we do not have a Retrofit Kit available at the time this manual was printed, you will need
to contact the manufacturer's representative directly to place an order. Addresses for the
manufacturers and their reps are listed below.
Monitor Products
502 Via Del Monte
Oceanside, CA 92054
(619) 433-4510/434-0255 (fax)
DLDI
13455 Ventura Blvd #220
Sherman Oaks, CA 91423
(408) 496-6996/(818) 995-6451 (fax)
Frequency
4.864MHz
4.864MHz
4.864MHz
Raltron
2315 NW 107th Ave.
Miami, FL 33172
(305) 593-6033/594-3973 (fax)
Kelex Electronics
16631 Milliken Ave.
Irvine, CA 92714
(714) 863-1230/474-1231 (fax)
I/O CALIB
screen (See
Stability
±1.5ppm (−25°C to +60°C)
±1ppm (0°C to +50°C)
±1ppm (−10°C to +50°C)
RXD
P.O. Box 1494
Norfolk, NE 68701
(402) 379-0112/379-3074 (fax)
California Capacitor
1579 Centre Pointe Dr.
Milpitas, CA 95035
(408) 262-6000/262-0272 (fax)
1 - 9
INTRODUCTION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents