Replenishing The Toner - Kyocera Mita KM-P4845w Operation Manual

2. Replenishing the Toner

When toner is insufficient the message "Add toner" is displayed.
When "Ready to print" is also displayed, printing is possible for a short
period of time; however, when the only "Add toner" message is
displayed and the Attention indicator on the operation panel is lit,
printing is no longer possible. Replenish toner promptly.
When several consecutive prints contain large areas of saturated
black, large quantities of toner are used at once and the message
"Add toner" may be displayed even when a supply of toner remains in
the printer. In this case, open and then close the toner replenishing
slot. The printer will perform toner replenishment.
Inch specifications
Metric specifications
1
Turn the screws on both sides of the toner replenishing slot
and align them as shown to open the toner replenishing slot.
2 Grasp the replenishment toner bottle upside down and tap
the bottom of the bottle 10 times.
CHAPTER 6 TROUBLESHOOTING
CAUTION
DO NOT attempt to incinerate the toner containers or
the waste toner tank. Dangerous sparks may cause
burns.
CAUTION
DO NOT attempt to force open or destroy the toner
containers or the waste toner tank.
3 Shake the replenishment toner bottle up and down 10 times,
and grasp it horizontally and shake it side to side 10 times.
Align the M portion of the toner bottle with the pin 1 (metal
4
protrusion) of the opening to insert the bottle as shown in the
illustration.
1
6-3