Kyocera Mita KM-P4845w Operation Manual page 39

G Configuration by manager
1 Press the */Menu key.
2 Press the N or M key to select "2. Set/manager".
Inch specifications
Metric specifications
Press the Enter key.
3
4
Use the MNOP cursor keys to input the pin code (the
default setting is qQrR).
Inch specifications
Metric specifications
NOTE
The pin code may be changed (see "13. Mgr. code change" on page
5-10).
CHAPTER 5 MANAGEMENT AND SETTING
Press the N or M key to select "1. Set machine".
5
Inch specifications
Metric specifications
Press the Enter key.
6
7 Press the N or M key to select a setting and press the Enter
key.
Inch specifications
Metric specifications
Configure each item, referring to the following pages:
1. Paper width···Page 5-6
2. Media Type [Pre-set Temp.]···Page 5-6
3. Paper type [Paper material]···Page 5-6
4. Roll end···Page 5-7
5. Auto shutoff···Page 5-7
6. Timer set···Page 5-7
7. Size adjustment···Page 5-8
8. Fusing temp.···Page 5-9
9. Custom paper···Page 5-9
10. Standard size···Page 5-9
11. Auto roll over···Page 5-10
12. Buzzer···Page 5-10
13. Mgr. code change···Page 5-10
* The "*" in a list of setting options indicates the current
setting.
8 To configure another item, return to step 6.
To complete configuration, press the N or M key to select
"End" ["back"] and press the Enter key.
NOTE
• After each item has been configured, press the */Menu key to return
to the "Ready to print." screen.
• If you make a mistake when configuring an item, press the */Menu
key. The display will return to the "Ready to print." screen, leaving
the setting unchanged.
9 Press the N or M key to select "End" and press the Enter
key.
5-5