Dc In Connector - Sony HDC-X300 Operation Manual

c TRIGGER connector (BNC type)
When the camera is in Still mode, this connector functions
as the still-picture trigger input. While this connector is on
the ground level, the camera output still pictures.
When the camera is in 24P (2-3 pulldown) mode, the
connector functions as the 2-3 pull-down sequence signal
connector.
The input and output is TTL level.
Switching between Still mode and 24P mode and input/
output setting of 2-3 pulldown sequence signals are
achieved using the MAINTENANCE menu.
d GENLOCK IN connector (BNC type)
This accepts analog HD (3-level sync) or SD (2-level sync)
signal.
Note
Any signal that does not match the vertical sync of the
output signal of the camera is not accepted. When the
HFU-X310 is connected to the HDC-X310/X310K via an
optical fiber cable, input to the GENLOCK IN connector
is not accepted.
e REMOTE connector (8-pin)
Connect a camera control device, such as the RCP-700/
750-series, RM-B750/B150, or MSU-700-series unit.
Notes
• The camera control devices are not exclusive to this
camera. Some of the switches and menu items may not
be operative with this camera.
• If a camera control device is connected to the REMOTE
connector of the HFU-X310 and another camera control
device is connected to that of the HDC-X310/X310K
when the HFU-X310 and HDC-X310/X310K are
connected via optical fiber cables, operations of the
camera control devices are not guaranteed.
f DC IN connector
Connect to a power source via the supplied AC adaptor.
g VIDEO OUT connector (HD D-sub 15-pin)
This outputs video signals. The output format can be
selected using the DIP switch on the side panel.
h OFC (optical fiber cable) connectors (HDC-
X310/X310K)
For video and control signal connection via a single mode
optical fiber cable.
For details on connection with the HFU-X310, see
"Connecting Optical Fiber Cables (HDC-X310/X310K)"
on page 23.
Locations and Functions of Parts
17