Graco System 2500 Owner's Manual page 7

Connect the Fluid and Air Supply
See Fig. 3
D The System ProCartt provides the air supply for
the remote pressure pot.
D The circled letters in Fig. 3 indicate hose line
connections.
1. Connect gun air supply hose (A) between turbine
air outlet (B) and gun air inlet (C). DO NOT use
wrench to tighten connections; hand tighten only.
The System 4900t turbine uses a quick connector
at outlet (B). A wrench is not required for hose
connection.
E
G
Y
remote pressure pot setup for spray gun
K
J
to
compressor/
cart
F
1
2 / -gallon remote pressure pot
2
Fig. 3
Setup
C
A
X
X
H
G
Y
System 4900t Turbine
2. If using a spray gun cup (D):
connect the cup to the gun fluid inlet (E).
If using accessory remote pressure pot (F):
connect fluid supply hose (G) between remote
pressure pot fluid outlet (H) and gun fluid inlet (E).
Connect pressure pot air hose (J) between
pressure pot air regulator inlet (K) and the
compressor/cart air outlet.
Connect to Electric Supply
Plug turbine power cord into grounded outlet.
NOTE: Extension cord must be 3-wire, 12 AWG, 50 ft
(15 m) or shorter.
D
cup-over option
(see manual 309205)
E
B
D
C
A
X
cup setup for spray gun
G K J
H
Z
Y
F
ti7064a
2-quart remote pressure pot
309246
to
compressor
4958C
7