Assembly - Sony DCR-VX2000 Service Manual

2-12.CD-254, SE-108 BOARDS, ZOOM LENS ASSEMBLY
4 Three tapping screws
5 SE-108 board
3 Flexible board (6P)
(from zoom lens assembly)
9 Zoom lens
(VCL-6012WB)
REMOVING THE ZOOM LENS ASSEMBLY
4 Ornamental ring assembly
Rotate it in the direction of
the arrow C and remove it
in the direction of the arrow D .
C
D
2-13.CONTROL SWITCH BLOCK (PS-4980), CONTROL SWITCH BLOCK (CF-4980)
9 Two tapping
screws
(B2 × 5)
(B2 × 5)
6 CCD emblem
7 Rubber foot (A)
8 Name ring
B
A
1 Tapping screw (M1.7 × 4)
5 VAP assembly
5 Control switch block
(PS-4980)
3 Control switch block
(CF-4980)
1 Tapping screw
(B2 × 5)
4 Two tapping screws
(B2 × 5)
2 Control switch block (PS-4980)
(8P)
7 Four tapping screws
(B2 × 5)
8 Slider assembly
PRECAUTION DURING
INSTALLATION
Install the slider assembly
while pushing the eject lever
fully to the left (CCW).
REMOVING THE CD-254 BOARD
8 Remove the soldering.
9 CJ-064 harness
3 Remove the
sixteen solderings.
6 Prism
2 Two tapping
screws (B2 × 7)
3 Zoom lens assembly
Rotate it in the direction of
the arrow A and remove it
in the direction of the arrow B .
6 Push the eject knob in
the direction of the arrow,
and open the cassette lid.
q; Control switch block (CF-4980)
Be careful not to damage
the control switch block's
(CF-4980) flexible.
Eject lever
2-11
1 Three tapping
screws (M1.7 × 7)
2 (CCD) flexible
block assembly
q; CD-254 board
4 Remove the
sixteen solderings.
5 Remove the
sixteen solderings.
2 Prism cover
1 CCD
heat sink

assembly

Cassette lid
Eject knob
7 Sheet (CD)