HELIX PP50 DSP Manual page 21

Connection and installation of HELIX Optical & USB Interface
using the PP50 DSP PC Tool. The software displays all DSP functions in a user-friendly format so that they
can each be adjusted as desired. The software and associated installation instructions can be downloaded
You must install the HELIX Optical & USB Interface before you can use the software with the PP50 DSP.
Use the following steps to ensure a smooth installation.
Important:
Make sure the HELIX Optical & USB Interface is not
connected to your PC prior to software installation.
Connect and use it only after the software has been
completely installed on your computer.
To ensure fault-free operation, always use the la-
communicates with the interface and the PC tool
PP50 DSP. If it is inadvertently deleted or does
not function correctly, it can be downloaded from
Downloads PP50 DSP Setups
and installed using the Instructions on page 20.
Software installation:
1. Download the software from the home page pre-
viously mentioned from under the „Download"
section to your computers hard drive.
Important: This folder may not be on a portable
storage device such as a USB thumb drive - it
must be saved on the hard drive.
install the interface driver. This must be done
before the „PP50 DSP PC-Tool.exe„ program is
started.
Note: The installation may last up to one minute.
The software is ready for use once the driver in-
stallation has completed. The interface can now
be connected.
Interface connection:
1. Connect the red HELIX Optical & USB Interface
plug to the red CONTROL INPUT on the PP50
DSP.
Note: The plug can only be inserted in one direc-
tion. Do not try to insert it incorrectly by forceas
damage will occur.
2. Connect the interface USB plug to a USB port on
your PC.
3. Switch the PP50 DSP on via your car radio. The
Factory Setups
be operated and adjusted using the software.
Note: Comprehensive operating instructions for
the HELIX PP50 DSP PC Tool can be downloa-
ded from
21