Table of Contents
Advertisement
Notice to Users
After a suitable place has been selected for the installation of the e-STUDIO18, please do not change it. Avoid excessive heat, dust,
vibration and direct sunlight. Also, provide proper ventilation as the copier emits a small amount of ozone.
For the U.S.A. only
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
WARNING
Changes or modification made to this equipment, not expressly approved by TOSHIBA TEC or parties authorized by TOSHIBA TEC,
could void the user's authority to operate the equipment.
User Safety
This TOSHIBA multifunctional digital systems does not produce laser radiation hazardous to the user. It is certified as a Class 1 laser
product under the U.S Department of Health and Human Services (DHHS) Radiation Performance Standard according to the
Radiation Control Health and Safety Act of 1968 including amendments.
Protective housing and external covers completely confine the laser beam light emitted inside the multifunctional digital systems. The
laser beam cannot escape from the machine during any phase of user operation.
Regulations implemented on August 2, 1976 by the Bureau of Radiological Health (BRH) of the U.S Food and Drug Administration
apply to laser products manufactured from August 1,1976. Laser products marketed in the United States must comply with these
regulations.
CAUTION
Using controls or adjustments or performing procedures, other than those specified herein may result in hazardous radiation
exposure.
For the U.S.A. and Canada
Regulatory Information
TOSHIBA is dedicated to preserving the environment by sponsoring Call2Recycle, a program of the Rechargeable Battery Recycling
Corporation. For more information and for drop-off locations, visit www.rbrc.org or call 1-800-822-8837.
Notice regarding CR coin cell batteries, applicable to California, U.S.A. only: Perchlorate Material - special handling may apply.
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate/
The unit is classified as Class 1 Laser Product according to IEC60825-1:1993, IEC60825-1:2007 including amendments.
The unit uses laser diode of output Max. 5 mW, wave length 770 - 795 nm, continuous pulse.
Caution:
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
For Canada only
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Except the U.S.A. and Canada
The unit is classified as Class 1 Laser Product according to IEC60825-1:1993, IEC60825-1:2007 including amendments.
The unit uses laser diode of output Max. 5 mW, wave length 770 - 795 nm, continuous pulse.
Caution:
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation
exposure.
6
Notice to Users
Advertisement
Table of Contents
