Tycon Power Systems TP2700WC Operation Manual page 36

Problem
Temperature sensor
reads too high in the
day time.
Indoor and Outdoor
Temperature do not
agree.
Indoor and Outdoor
Humidity do not
agree.
Solution
as an RF shield), or earth barrier
(down a hill).
5. Move the Base Station away
from electrical noise generating
devices, such as computers,
TVs
transmitters or receivers.
6. Move the remote sensor to a
higher location or Move the
remote
location.
If possible shade the transmitter without
shading the solar panel.
1. Allow up to one hour for the sensors
to stabilize due to signal filtering.
The indoor and outdoor temperature
sensors should agree within 4 °F
(the sensor accuracy is ± 2 °F).
2. Perform a temperature calibration
(reference Section 2.1).
1. Allow up to one hour for the sensors
to stabilize due to signal filtering.
The indoor and outdoor humidity
sensors should agree within 10 %
(the sensor accuracy is ± 5 %)
2. Perform
(reference Section 2.1).
36
and other
sensor to
a humidity
wireless
a closer
calibration
8000040 Rev 3