Tycon Power Systems TP2700WC Operation Manual page 34

Problem Solution
transmitter. Always wait at least 2 minutes
after removing
re-inserting to the transmitter.
If the batteries were recently replaced,
check the polarity. If the sensor is flashing
every 48 seconds, proceed to the next step.
There may be a temporary loss of
communication due to reception loss related
to interference or other location factors, or
the batteries may have been changed in the
remote and the Base Station has not been
reset. The solution may be as simple as
powering down and up the Base Station.
1. Make sure you have fresh
batteries in the Base Station.
2. With the sensor array and Base
Station 10 feet away from each
other, remove the batteries from
the Base Station and wait 10
seconds. Put the batteries back
in.
3. Do not touch any buttons for
several minutes.
4. The remote sensor search icon
Wait several minutes for this
icon to turn off.
34
the batteries
will splash on the display.
before
8000040 Rev 3