Destination Management - Skoda Infotainment Navigation Amundsen Operating Instructions Manual

A route can contain a maximum of twenty stopovers.
The individual destinations can be mutually replaced by touching the function
key for one destination  and moving it to another position. It is not possible
to replace already reached destinations with each other.
When you press the name of the destination or stopover, the system displays
the following menu where you can edit the destination.
Delete the destination or the stopover

the route guidance is continued from this destination (previous stopovers

are skipped)
Open the destination details

No route guidance follows - enter a new tour
›
Press in the menu Navigation function key  My tours → New tour - the
following menu for entering a new tour opens.
New dest. - Enter a new route destination
A
Destinations - Select a route destination from the list of stored destina-
B
tions » page 66
Store - Save the route in the tour memory
C
Start - Calculate the specified route and start the route guidance
D
After the route has been calculated, the unit displays the arrival times at the
individual destinations and the remaining distance to the destination.
Route guidance follows - Tour editing
›
Press in the menu Navigation function key  My tours → Edit Tour - the fol-
lowing route processing menu opens.
The route guidance is not cancelled.
New dest. - enter a new route destination
A
Destinations - select a route destination from the list of stored destina-
B
tions » page 66
Store - Save the route in the tour memory
C
Stop - Stop the route guidance
E
Stopover with sequential number

final destination

expected arrival time at the final destination or stopover

Distance to final destination or stopover

74
Navigation
» page 75
With destinations on the route already reached the text Destination reached
is displayed below the destination name. It is not possible to switch these des-
tinations with each another.
Tour memory
›
Press in the menu Navigation function key  My tours → Tour memory to
open a list containing all saved routes.
By confirming a route in the list, a menu for the selected route is opened with
destinations » page 73, New Tour / Tour editing.
Then it is possible to start or edit the destinations on the selected route guid-
ance.

Destination management


Introduction
This chapter contains information on the following subjects:
Stopover
Destination details
First and foremost, pay attention to the safety instructions
tant notes.
Stopover
It is possible to add up to twenty destinations to the route during route guid-
ance. The route guidance is according to the sequence of the stopovers on the
route. After the next stopover has been reached, route guidance to the follow-
ing stopover continues.
›
Press in the menu Navigation function key  New dest./stopover - a menu
opens for entering a new destination
menu for destination details » page
If the route guidance is active, then after confirming with the option Start the
device shows after entering the stopover the message, Route guidance is al-
ready active. Would you like to start direct route guidance to new the desti-
nation, or to add the new destination as a stopover? and the following menu:
» page 7, Impor-
» page 63 and then in the next step a
75.
74
75
