Changing The Engine Oil; Lubricating The Hex Shaft - Toro Power Max 38801 Operator's Manual

Changing the Engine Oil

Service Interval: After the first 5 hours—Change the engine
oil.
Every 50 hours—Change the engine oil. Change the
engine oil every 25 operating hours when operating
the engine under a heavy load.
If possible, run the engine just before changing the oil because
warm oil flows better and carries more contaminants.
Use automotive detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher. Refer to your engine owner's
manual.
Use Figure 51 below to select the best oil viscosity for the
outdoor temperature range expected:
Engine Oil Capacities
Model
38801
38802
1. Clean the area around the oil drain cap (Figure 52).
G016496
1. Oil drain plug
2. Slide an oil drain pan under the drain extension and
remove the oil drain plug.
Figure 51
Engine Oil Capacity
0.89 to 0.95 L(30 to 32 oz)
Figure 52
Note: When removing the plug, ensure the tube does
not loosen.
3. Drain the oil.
Note: Dispose of the used oil properly at a local
recycling center.
4. Install the oil drain plug.
5. Fill the crankcase with oil. Refer to 6 Filling the Engine
with Oil (page 11).

Lubricating the Hex Shaft

Service Interval: Yearly—Lubricate the hex shaft.
Lightly lubricate the hex shaft yearly with automotive engine
oil (Figure 53).
1. Hex shaft
2. Aluminum friction plate
Important: Do not get oil on the rubber wheel or the
aluminum friction drive plate because the traction drive
will slip (Figure 53).
1. Drain the gasoline from the fuel tank.
2. Tip the machine forward onto its auger housing and
block it so that it cannot fall.
3. Remove the back cover (Figure 54).
1
1. Back cover
4. Move the speed selector lever to Position R2.
5. Dip your finger in automotive engine oil and lightly
lubricate hex shaft.
24
Figure 53
3. Rubber wheel
Figure 54