Forming The Flat Cable; Changing The Channel Selector From 16-Channel; Connection Place Of The Antenna Hot Pin And Antenna Terminal; Align The Sp/Mic Lead Wire - Kenwood NX-320 Series Service Manual

NX-320
■ Forming the fl at cable
Form the right and left end of the fl at cable as shown in
the fi gure. (Bend the terminal surface of the fl at cable on
the inside.)
Note: When bending the flat cable, bend it squarely.
There is a possibility of disconnecting when the fl at cable
is bent too much.
Flat cable

■ Changing the channel selector from 16-channel

operation to free (without LCD models only)
1. Remove the channel selector knob q. (Refer to page 8
for how to remove the channel selector knob.)
2. Remove the knob spring w. (Refer to page 8 for how to
remove the knob spring.)
3. Remove the mechanical stopper e. (Refer to page 8 for
how to remove the mechanical stopper.)
4. Reassemble the channel selector knob and knob spring
that were removed in steps 1 and 2, in their original posi-
tions.
Note: Refer to page 8 for how to install the channel se-
lector knob and knob spring.
■ Changing the channel selector from free opera-
tion to 16-channel (with LCD models only)
1. Remove the channel selector knob q. (Refer to page 8
for how to remove the channel selector knob.)
2. Remove the knob spring w. (Refer to page 8 for how to
remove the knob spring.)
3. Pinch the supplied mechanical stopper e using your fi n-
gers, then install it into the groove of the selector part on
the case.
4. Reassemble the channel selector knob and knob spring
that were removed in steps 1 and 2, in their original posi-
tions.
10
DISASSEMBLY FOR REPAIR
Note: Refer to page 8 for how to install the channel se-
lector knob and knob spring.
■ Connection place of the antenna hot pin and
antenna terminal
An antenna hot pin is connected with the antenna termi-
nal at the position shown in the fi gure.
Confi rm that the antenna hot pin has fi rmly come in con-
tact with the terminal when the TX-RX unit is tightened
with the screw.
Additionally, refer to the following fi gures for the connec-
tion place of the antenna terminal and the TX-RX unit.
Antenna
Antenna
terminal
hot pin

■ Align the SP/MIC lead wire

Align the SP/MIC lead wire as shown in the fi gure. It is
possible to fi x temporarily by interweaving the two lead
wires between the tabs (tab A and tab B) and boss of the
speaker holder.
TX-RX unit
Antenna
terminal
B
A