Kenwood NX-320 Series Service Manual page 65

Item
Panel tuning mode
Maximum 1) Adj item: [NDEV]
Deviation Adjust: [✳✳✳✳]
(NXDN) *3 2) Adj item: [N.DEV_]→
[N.D.EV_]→[N.D.E.V_]→
[Very [N.D.E.V._]→[N.D.E.V._.]
Narrow] Adjust: [✳✳✳✳]
PTT: ON
Press [B] key to
store the adjust-
ment value.
5. Maximum 1) Adj item: [ADEV]
Deviation Adjust: [✳✳✳✳.]
(Analog) *3 Deviation meter
LPF: 15kHz
[Narrow] HPF: OFF
2) Adj item: [A.DEV_]→
[A.D.EV_]→[A.D.E.V_]→
[A.D.E.V._]→[A.D.E.V._.]
Adjust: [✳✳✳✳.]
PTT: ON
Press [B] key to
store the adjust-
ment value.
[Wide 4k] 1) Adj item: [ADEV]
Adjust: [✳✳✳.✳.]
2) Adj item: [A.DEV_]→
[A.D.EV_]→[A.D.E.V_]→
[A.D.E.V._]→[A.D.E.V._.]
Adjust: [✳✳✳.✳.]
PTT: ON
Press [B] key to
store the adjust-
ment value.
ADJUSTMENT (E TYPE)
Condition
PC test mode
equipment
1) Adj item: [Maximum Deviation
Deviation (NXDN meter
Very Narrow)] Oscilloscope
2) Adj item: [Low],
[Low'], [Center],
[High'], [High]
PTT: Press
[Transmit] button.
Press [Apply All]
button to store the
adjustment value.
1) Adj item: [Maximum
Deviation (Analog
Narrow)]
Deviation meter
LPF: 15kHz
HPF: OFF
2) Adj item: [Low],
[Low'], [Center],
[High'], [High]
PTT: Press
[Transmit] button.
Press [Apply All]
button to store the
adjustment value.
1) Adj item: [Maximum
Deviation (Analog
Wide 4k)]
2) Adj item: [Low],
[Low'], [Center],
[High'], [High]
PTT: Press
[Transmit] button.
Press [Apply All]
button to store the
adjustment value.
Measurement
Test-
Unit Terminal Unit
Panel ANT Panel
NX-320
Adjustment
Specifi cations /
Parts Method
[Panel 1337Hz 1311~1363Hz
tuning Write the value as
mode] followings. [PC test mode]
Selector 513 (Reference Press [Apply All]
value) button to store the
[PC test adjustment value
mode] after all adjustment
[ ],[ ] points have been
adjusted.
2100Hz 2050~2150Hz
Write the value as
followings. [PC test mode]
513 (Reference Press [Apply All]
value) button to store the
adjustment value
after all adjustment
points have been
adjusted.
3360Hz 3310~3410Hz
Write the value as
followings. [PC test mode]
513 (Reference Press [Apply All]
value) button to store the
adjustment value
after all adjustment
points have been
adjusted.
Remarks
65