Fly Sky FS-i10 Instruction Manual page 22

Digital proportional radio control system
14.
Stick mode adjustment
Stick Mode Adjustment
The mode can be changed based on user preferences
The instructions for changing default mode 2 are detailed below:
1. Touch system option to select the stick mode as shown in picture 14.1.
2. Change mode to 4.
3. Adjustment of mode 1 and mode 3 as shown in pictures 14.3 and 14.4
1). Change mode 1 and mode 3 to mode 1 or mode 3.
2). Open the battery box and remove the battery.
3). Remove the transmitters left and right grips.
4). Use the inner hexagonal screwdriver to remove the six screws on the
back of the transmitter and put them in a safe place as shown in
picture 14.5.
5). Disconnect the transmitter back cover plug carefully and you will see
the layout as shown in picture 14.6.
6). Remove the eight screws with a small cross screwdriver and put them
in a safe place.
7). Switch the left and right gimbal, rotate 180 degrees, adjust the wire
and then lock the screw.
8). Insert the transmitter back cover wire to main board. Then close the
back cover and lock the screw.
9). Install the left and right grip, and then install the battery. After that,
close the battery cover.
10). Turn on the transmitter to ensure the channel and direction are working
correctly by touching the servo display. Check the trim direction by
sliding the trim.
six screws
18
( pic 14.5)
(Pic 14.1) (Pic14.2)
(Pic 14.3) (Pic 14.4)
( pic 14.6)
right gimbal
eight screws
left gimbal
5 21