Table of Contents
Advertisement
Available languages
Available languages
STARTING
Prior to starting, refer to your engine
manual for proper starting procedure.
1.
In a well ventilated outdoor
area add fresh, high quality,
unleaded gasoline with a pump
octane rating of 86 or higher. Do
not overfill. Wipe up spilled fuel
before starting the engine. Refer
to Engine Owners Manual for cor-
rect procedure.
2.
Check engine oil level. See
Engine Owners Manual for correct
procedure.
3.
Connect the water hose to the
water source. Turn the water
source on to remove all air from
the hose. When a steady stream
of water is present, turn the water
source off.
4.
Verify the
Filter Screen
filter screen
is in water
inlet of pump.
5.
Connect water source to pump
inlet. NOTE: Water source must
provide a minimum of 5 gallons
(18.9 liters) per minute at 20 PSI
(137.9 kPa).
To reduce the pos-
sibility of contami-
nation always protect against back-
flow when connected to a potable
water system.
6.
Connect high pressure hose to
pump outlet.
Water
Source
7.
If applying a chemical or clean-
ing solution, see How To Apply
Chemicals/Cleaning Solvents
instructions in this section.
8.
do so could cause damage to the
pump.
9.
10. Start engine. See Engine Owners
does not start after two pulls,
squeeze trigger of gun to relieve
pump pressure. Pull starter cord
slowly until resistance is felt. Then
pull cord rapidly to avoid kickback
and prevent hand or arm injury.
11. Depress trigger on gun to start
a stable surface and grip gun/spray
wand firmly with both hands. Expect
the gun to kick when triggered.
12. Release trigger to stop water
engage the trigger lock when gun
is not in use. Failure to do so could
cause accidental spraying.
High Pressure
Hose Hook-up
13. Adjust nozzle spray for the task
13- ENG
Turn water source on.
Risk of property
damage. Failure to
Remove all air from the pump
and high pressure hose by
depressing trigger until a steady
stream of water is present.
Manual for correct procedure.
Risk of unsafe
operation. If engine
water flow.
Risk of unsafe
operation. Stand on
flow.
Risk of injury from
spray. Always
Trigger Lock Engaged
being performed. See How To Use
Wand instructions in this section.
Advertisement
Table of Contents
