MCQUAY Service Guide Book
4.4 G17
Operation Guide
1. Transmission Source
2. Signal Transmission Indication
•
Blink to confirm that the last setting
has been transmitted to the unit.
3. Temperature Setting
•
Temperature setting range is from
16°C to 30°C (optional setting 20°C to
30°C).
4. Personalize Setting
•
Press
and hold for 3s, then
blink. Press again to cycle between
and
.
•
Set the desire setting, then leave the
handset for 4s without pressing any key
and it will save the setting into the
program.
•
Press
once to activate the P1 setting,
press again to cycle between P1 and P2.
•
Press
any
personalize setting.
5. Automatic Air Swing (optional)
•
Press the SWING
the automatic air swing function. Press
again to stop the louver at the desired
direction.
key
to
deactivate
button to activate
6a. Silent Function (For WM – J Series only)
•
Press
•
Fan speed turn to minimum speed.
•
Press again to deactivate the function.
6b. Ionizer Function (For WM - G series only)
•
Press
ion function, which will refresh the indoor
air effectively.
7. Sleep Mode Setting
•
This function is available under COOL,
HEAT and AUTO mode.
•
When under cooling mode, the set
temperature is increased by 0.5°C after
30 minutes, 1°C after an hour, and 2°C
after 2 hours.
•
When under heating mode, the set
temperature is decreased by 1°C after 30
minutes, 2°C after an hour, and 3°C after
2 hours.
8. Operating Mode
•
Press the MODE button to select the type
of operating mode.
•
For cooling only unit, the available modes
are: COOL, DRY and FAN.
9. Fan Speed Selection
•
Press the
toggle the fan speed in the following
order:
Low
•
Stop pressing when the desired fan speed
appears on the display screen.
will
10. "ON/OFF" Button
11. Timer Cancel
12. OFF Timer Setting
13. ON Timer Setting
14. Turbo Function
the
•
Press
•
Fan speed turn to maximum speed.
•
Press again to deactivate the function.
15. Clock Time Setting
•
Press
9
Handset Operating Guide
for quiet operation.
button to activate the negative
button continuously will
Med
High
for fast cooling.
and hold to set the clock time.
Auto