Alarm Service Settings - Foscam FI8918E User Manual

WWW.FOSCAM.COM FI8918E User Manual
Enable Set Filename: You can set a name for the uploaded image when you enable the
checkbox. If you select it, the uploaded image will be named after the filename you set. So the
next image will cover the last image and the FTP Upload Folder will only have one uploaded
image which named after the filename you set.
Filename: Fill in a name for the uploaded image. This name is different from the alarm image.
You cannot change the name of the alarm image.
Click Submit to save these settings. Click Test. The following screen displays if it succeeded.
(Figure 3.24).
Figure 3.24
The following errors may occur:
1) Can not connect to the server. Check if the FTP Server is correct.
2) Network Error. Please try later.
3) Server Error.
4) Incorrect user or password. Check the username and password.
5) Cannot access the folder. Verify the folder exists and your account is authorized
6) Error in PASV mode. Verify the server supports PASV mode
7) Error in PORT mode. PASV mode should be selected if the device is behind a NAT
8) Cannot upload file. Verify your account is authorized
Check parameters. The format of image is similar to
00606E8C1930(sarah)_0_20100728114350_25.jpg
Check if your FTP server supports this file name format

3.12 Alarm Service Settings

If you enable Motion Detect Armed, it will send email alerts and upload images when motion
has been detected.
33
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: 86 755 2674 5668 Fax: 86 755 2674 5168