Table of Contents
Advertisement
8
Removing t hePedestal S tand
1 ) Carefully
lay the front of the unit face down on a
flat, cushioned
surface such as a quilt or blanket.
Leave the stand protruding over the edge of the
surface.
Note: Extreme care should always be used when
removing
the pedestal
stand to avoid damage
to
the L CD panel.
2) Remove the stand screws shown in the diagram.
This will allow removal of the pedestal stand.
3) Once you have removed all screws holding the
pedestal
stand in place, remove the pedestal
stand from the TV.
CAUTION:
Always place the TV on a sturdy, level,
stable surface that can support the weight of the
unit. To secure the TV, use a sturdy strap from the
hook(s) on the rear of the TV to a wall stud, pillar,
or other immovable
structure. Make sure the strap
is tight, secure, and parallel to the floor.
65L9400U
VEgA MountingPattern
..... .Hi
Two stand screws _-_'_
_w0//\\
stand screws
Two clips
(Sample
Illustration)
58L8400U
VESAMounting Pattern
Two stand screws
Two stand screws
(Sample Illustration)
FCCBec/aration of Conformity
Compliance Statement (Part 15):
Toshiba
television
model
65L9400U
and 58L8400U
comply with Part 15 of the FCC Rules.
Operation is subject to the _bllowing two conditions:
(1) This device may not cause harmflfl interference,
and
(2) This device must accept any interference
received,
including imerf_rence that may cause undesired operation.
The party responsible
for compliance
to these rules is:
Toshiba America In_brmation Systems, Inc. 9740 Irvine
Blvd., Irvine, CA 92618. Phone: 800-d31-3811
Note: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant
to Part 15 of the FCC Rules. These limits
are designed to provide
reasonable
protection
against
harmful interference
in a residential
installation.
This
equipment generates,
uses and can radiate radio
frequency
energy and, if not installed and used in
accordance
with the instructions,
may cause harmful
interference
to radio communications.
However,
there
is no guarantee
that interference
will not occur in a
particular
instaflation.
If this equipment
does cause
harmful interference
to radio or television reception,
which can be determined by removing and applying
power to the equipment,
the user is encouraged
to
try to correct the interference
by one or more of the
following measures:
Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and
receiver.
. Connect the equipment imo an outlet on a circuit
diIt?rem from that to which the receiver is connected.
. Consult the dealer or an experienced radioiTV technician
tbr help.
Caution:
Changes or modifications
to this equipment
not expressly
approved by Toshiba could void the
user's authodty to operate this equipment.
Wireless Radio
For products availabie in the USA Canada market,
only channel 1 ll can be operated. Selection of other
channels is not possible. The device can automatically
discontinue transmission
in case of absence of infbrmation
to transmit, or operational Ihilure. Note that this is not
intended to prohibit transmission
of control or signaling
inlbrmation or the use of repetitive codes where required
by the technology. If this device is going to be operated in
5.15 5.25 GHz fl'equency range, then it is restricted to an
indoor environment
only.
important:
Any changes
or modifications
not
expressly approved by the party responsible
for
compliance
could void the user's authority to operate
this equipment.
This device and its antenna(s)
must
not be co-located
or operating
in conjunction
with any
other antenna or transmitten
Advertisement
Table of Contents
