Table of Contents
Advertisement
6
Initial Setup and Menu
Pel_n"ming the initial setup
Model
Name
1
2
Press the GREEN button.
The Model Name screen wilt appear.
Use the A/V (arrow) buttons to select the model name then
press the OK button.
o:o Select a field and press the OK button to show the
software keyboard. Enter the first few characters of the
model name and press the GREEN button. The model
name starting with the entered characters will appear on
the Model Name screen.
NOlr£
Youdo not need to set bothmodelnameandcodeset.If youselectModel
Name and pressOK,it will takeyoudirectlyto theinput & Node key
screen andskip thecodeset.
Thecodeset shouldbe selected onlywhenyouknowthecodeset.
Code Set
1
Use the 4/P" (arrow) buttons to select the code.
o:. After the code is selected, press the RED button to show
the Test screen. The test wilt start automatically.
NO'rN
If a modelhasmorethanoneCodeSet,a message w ill appear stating"This
model h asmorethanoneCodeSet.Please selectandtestyourpreferred
CodeSet."Youwill need to choosea codesetusingthe A/T
(arrow)
buttonsandperform theTestoptionto ensure the correct C odeSethas
been selected.
2
Press the OK button.
Input & Mode Key screen wilt appear.
Input & Mode Key
1
Use the 4/_
(arrow) buttons to select the TV input to which
the IR device is connected.
•:,
--- (Appears when Device Type is set to Receiver, Misc
Audio or Amplifier)
•*,, ANT/CABLE
o**oVideo 1
o**oVideo2
o*,o ColorStream HD
Advertisement
Table of Contents
