Table of Contents
Advertisement
3.6.3
Power Requirements for IBM 468X/469X
POS/ECR Direct Connect
The SCANTEAM 8300/8310 draws all its power from the IBM
POS when configured for this application. Since different ports
on the IBM POS offer +5 or +12 volts, the interface connector
system on the SCANTEAM 8300/8310 is designed to accept and
operate the reader from either voltage supplied through the IBM
POS cable.
3.6.4
Power Requirements for OCR Direct Connect
The SCANTEAM 8300/8310 can be configured to draw all its
power from an IBM or Fujitsu POS device when configured for
these host interfaces. Field experience has shown that some
Fujitsu systems do not have adequate +5 volt DC power to
supply the check reader requirements. For these Fujitsu
systems an external power pack and an external power (EP) type
host interface cable are required.
3.6.5
Wand Emulation Applications
When the SCANTEAM 8300/8310 is connected with wand
emulation host communications, you may choose to have the
terminal supply power through the wand port interface
connector. Depending on the power capacity of the host device,
an external power pack may be required for this interface
configuration.
Hardware Interface Description
3–10
Hide quick links:
Advertisement
Table of Contents
