Setting Display Brightness; Selecting Tracvision Or Gyrotrac-Only Operations - KVH Industries KVH TracVision TracVision G6 User Manual

3.2

Setting Display Brightness

The ADCU display's brightness may be adjusted to suit your
preferences. Press the right key to make the display brighter, the
left key to make it dimmer. When you are satisfied with the
setting, press the center key to accept the setting. Refer to the
Quick Reference Guide on page 18
this menu.
Set brightness?
Yes Next
Min Bright
*****************
im isplay Brighten isplay
3.3 Selecting TracVision or
GyroTrac-only Operations
GyroTrac's factory default configuration is to operate as a stand-
alone system (Antenna Comm: OFF). Connecting a TracVision
antenna will reconfigure GyroTrac to function as a component of
a TracVision system (Antenna Comm: ON). Refer to
Reference Guide on page 18
menu.
Set TV com On/Off?
Yes Next
Antenna Comm is: ON
On ENTER
54-0161-01
for instructions on reaching
Return
Max
The A CU display offers
20 levels of brightness,
each of which is indicated
by an asterix that appears
or disappears when the
im and Brighten keys are
pressed.
for instructions on reaching this
Return
he antenna communication
Off
setting will blink "ON" or "OFF"
based on current selection.
ON allows Gyro rac to
function as a racVision
system component. Pushing
the ON and OFF buttons will
change the selected setting.
Figure 3-2
Display Brightness Controls
If the antenna is not receiving data
from the GyroTrac and the ADCU is
not displaying antenna-specific
menus, it may be because the
the Quick
antenna communication is turned
off. Use this menu to check and
turn antenna communications back
on if necessary.
Figure 3-3
Selecting TracVision or
GyroTrac-only Operations
Using the ADCU Interface
19