Sony XC-ST50 Technical Manual page 11

ELECTRONIC SHUTTER
Specifications of trigger pulse
When using a trigger pulse like shown below, set the TRIG polarity selector switch on the rear panel to + :
A: 2 to 5.0 V
B: 0 to 0.6 V
T: 2 µs to 1/4 s, 100 µs to 1/4 s when setting the shutter speed using DIP switch
When using a trigger pulse like shown below, set the TRIG polarity selector switch on the rear panel to – :
A: 4.0 to 5.0 V
B: 0 to 2.0 V
T: 2 µs to 1/4 s, 100 µs to 1/4 s when setting the shutter speed using DIP switch
Input impedance: 10 kΩ or more
*
The voltage and pulse width used are measured at pin 11 of the 12-pin multi-connector on the rear panel.
*
Specifications of WEN (Write ENable Pulse)
A: 5.0 V
B: 0 V
T: 15.875 ms (XC-ST50/30), 18.752 ms (XC-ST50CE/30CE)
Output impedance: 10 kΩ or more
*
T
T
T
A
B
A
B
A
B
XC-ST50/50CE
XC-ST30/30CE
9