Table of Contents
Advertisement
!
If you do not follow these instructions exactly,
a fire or explosion may result causing property
damage, personal injury or loss of life.
Before operating, make certain the boiler and system are
full of water to minimum pressure (this is usually 12 psig
on most systems) and system is vented of air. See the
operating and lighting instructions.
OPERATING INSTRUCTIONS
FOR BOILER WITH A HOT SURFACE PILOT SYSTEM
FOR YOUR SAFETY, READ BEFORE OPERATING!
WARNING
A. This appliance is equipped with an ignition
device which automatically lights the
burner. Do not attempt to light the burner
by hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell
next to the floor because some gas is
heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
!
• Immediately call your gas supplier from
a neighbor's phone. Follow gas supplier's
instructions.
• If you cannot reach your gas supplier, call
the fire department.
C. Use only your hand to push down or turn
the knob. Never use tools. If the knob will
not operate by hand, don't try to repair it,
call a qualified service technician. Force
or attempted repair may result in fire or
explosion.
D. Do not use this appliance if any part
has been underwater. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
control system and any gas control which
has been under water.
13
WARNING
Advertisement
Table of Contents
