Import/Export A Configuration File; Using Ioadmin To Import/Export A Device Configuration - Moxa Technologies ioLogik W5300 Series User Manual

Table of Contents

ioLogik W5300

5. You can now test and monitor I/O status in ioAdmin.

NOTE

In this scenario, Active OPC Server is acting as middleware between the central configuration/control software

and the ioLogik W5300 remote I/O unit served over a cellular interface. To minimize bandwidth usage, click the

Refresh button manually to retrieve the settings.

Import/Export a Configuration File

To import or export a system configuration right click on the I/O model name and then selection Import

System Config or Export System Config. You must be logged in as an administrator to use this command.

Export System Config

Select this command to export the selected ioLogik's configuration to a text file. We recommend using this

method to back up your configuration after you have finished configuring the ioLogik for your application.

ATTENTION

Since there are major functional differences between firmware versions, exporting the configuration file

requires a longer processing time.

ioAdmin 3.10 or above, especially if earlier versions of ioAdmin have been installed and then removed.

Import System Config

Select this command to load a configuration for the selected ioLogik from a configuration text file. The new

configuration will not take effect until the ioLogik has been restarted. This command can be used to restore a

configuration after loading the factory defaults, or to duplicate a configuration to multiple ioLogik units.

ATTENTION

Since there are major function differences between firmware versions, the configuration file is not compatible

if using firmware V1.3 or above for the ioLogik W5312 series, and V1.5 or above for the ioLogik W5340 series.

The configuration file cannot be imported into firmware versions earlier than the above versions.

Be sure to check your firmware version carefully before importing/exporting and upgrading

firmware.

Adjust the TCP Socket Timeout Interval to 30 seconds

2-12

Getting Started

when using

Table of Contents