Set Date and Time
to reset the reader to initial configuration. See the PRG for
other options, and a listing of standard factory settings.
Set Date and Time
1.
Scan the Enter/Exit Programming barcode
below to set date and time.
2.
Scan the Set Date barcode + six digits for Year,
Month and Day (YYMMDD) from the
Numeric Keypad on page
3.
Scan Set Time + six digits for Hours, Minutes and
Seconds (HHMMSS) from the
pad on page
4.
Scan the Enter/Exit Programming barcode to
complete.
8
Factory defaults are based on the interface
type. Be sure your reader is configured for the
correct interface before scanning this label.
Reset Default Settings
ENTER/EXIT PROGRAMMING MODE
43.
43.
Set Date
Set Time
Hex-
Hex-Numeric Key-
PowerScan™ PBT9500