Pfaff 3371-10 series Instruction Manual page 46

Input
Group
11 - 12
Parameter Description
000 009 Via zero point to starting point after
end of sequence
With this parameter it is possible to
choose that, after the end of the
sequence, the X-, Y-drive moves to the
seam starting point via the reference
initiators.
010 Via zero point to starting point after
number of program cycles
Number of program cycles
With this parameter it is possible to
choose that, after a certain number of
program cycles, the X-, Y-drive moves
to the seam starting point via the
reference initiators.
011 Pedal mode
Switchover between level mode
(0) and flip flop mode (1).
012 Needle or balance wheel position in
degrees
013 NIS "needle in material" [°]
This parameter is used to set the NIS
signal. If the function is executed, the
position can be entered by turning the
balance wheel. If the position is altered,
the result is a change in the point of
time when the carriage is moved. The
access code is necessary for this
adjustment.
014 Thread trimming speed [min-1]
This parameter is used to fix the speed
for thread trimming.
015 Reduced current for stepping motors
The reduction function of the holding
current at rest with closed work clamp
is switched on or off.
016 Key tone
The key tone, as reaction to a key on
the control panel being pressed, is
switched on or off. The double tone
for incorrect inputs always remains
switched on.
Setting Set value
range
ON –OFF OFF
ON –OFF OFF
1 - 100
0 – 1 0
0 - 360 11
65 – 166 107
100 – 700 300
ON – OFF ON
ON – OFF ON