Input; Reserving Program Stations - Pfaff 3371-10 series Instruction Manual

11

Input

After the machine has been switched on, it is in the input mode. The letter combination "TE"
appears on the control panel display. The input mode is used to reserve program stations, to
enter sequences and to change machine parameters. In addition information and input
possibilities for the service area are available in this mode.
11

Reserving program stations

.01
P1 P8
The station keys P1 to P8 are used to enter and select seam programs. A complete seam
to
program is configured from the following parameter:
- seam pattern
- speed
- size factor in X-direction
- size factor in Y-direction
P3
In the input mode, select the desired program station, e.g. P3.
With the corresponding plus/minus key select the desired seam pattern, e.g. 20. The
seam patterns are stored in the machine under program numbers, see Chapter 11.06
20
Summary of the seam patterns.
Select the desired speed with the corresponding plus/minus key.
2200
X
Enter the desired size factor (in %) (X-direction) with the corresponding plus/minus key.
90
Y
Enter the desired size factor (in %) (Y-direction) with the corresponding plus/minus key.
110
TE
Conclude the input by pressing the TE key. (The machine changes to the sewing mode).
P4 P5 P7
P1 P2 P3 P6
TE
X Y
20 2200 90 110
The enlargement of the seam pattern is limited by the size of the machine's
sewing area.
P8
P
C1
C2
C3
TE
Input
11 - 1