Table of Contents
Advertisement
1-6. METHOD OF COPING WITH SHIFT LENS ERROR (UX7/UX7E)
LD-216 BOARD (SIDE A)
Measurement points on the LD-216 board
1-6-1. E : 62 : 02 [Abnormality of IC for Steadyshot] Occurred
Order
1
Turn the power OFF.
While measuring with an oscilloscope the output voltage of R5792 in the periphery of IC5703 on the LD-216 board, turn the
2
power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
If the output voltage change as shown in Fig. 2, replace the lens block (Note). If it does not change as shown in Fig. 2, inspect
3
the camera control circuit (IC1803 of VC-487 board) periphery.
Note: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
HDR-UX3E/UX5/UX5E/UX7/UX7E_L2
R5737
IC5703
R5721
Fig. 1
about 330 msec
Note: The length of low section will vary a little depending on the
conditions.
Change in output voltage of R5792 on the LD-216 board
VC-487 BOARD (SIDE B)
Measurement points on the VC-487 board
Procedure
1-4
ENGLISH
ENGLISH
Fig. 2
IC1803
Fig. 3
JAPANESE
JAPANESE
Advertisement
Table of Contents
