Table of Contents
Advertisement
1-1. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4 V), the power is shut off so
that the unit cannot operate.
These following method is available to prevent this.
Method:
Use the AC power adaptor (AC-L200/L200B).
1-2. TO TAKE OUT A DISC WHEN NOT EJECT (FORCE EJECT)
1 Remove the front cover assy.
2 Insert the wire etc. in the hole and up the lock arm by it.
1-3. PRECAUTION ON REPLACING THE VC-487 BOARD
DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Refer to Service Manual ADJ, and perform "DESTINATION DATA WRITE".
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Refer to Service Manual ADJ, and perform "USB SERIAL No. INPUT".
HDR-UX3E/UX5/UX5E/UX7/UX7E_L2
1. SERVICE NOTE
Claw
Front cover assy
Screw
1-1
ENGLISH
ENGLISH
Hole
JAPANESE
JAPANESE
Lock
arm
Advertisement
Table of Contents
