Method Of Coping With Shift Lens Error - Sony HDR-SR11 Service Manual

Digital hd video camera recorder
Hide thumbs Also See for HDR-SR11:
Table of Contents

Advertisement

1-3. METHOD OF COPING WITH SHIFT LENS ERROR

LD-230 BOARD (SIDE A)
IC5501
R5526
R5525
Measurement points on the LD-230 board and the VC-516 board
1-3-1. E : 62 : 02 [Abnormality of IC for Steadyshot] Occurred
Order
1
Turn the power OFF.
While measuring with an oscilloscope the output voltage of R5549 in the periphery of IC5501 on the LD-230 board, turn the
2
power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
If the output voltage change as shown in Fig. 2, replace the lens block (Note). If it does not change as shown in Fig. 2, inspect
3
the camera control circuit (IC1301 of VC-516 board) periphery.
Note: When the lens block was replaced, execute a necessary adjustment items referring to Service Manual, ADJ.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
HDR-SR11/SR11E/SR12/SR12E_L2
VC-516 BOARD (SIDE A)
R5549
R5534
R5549: No Mount
(Short Land)
C5513
Fig. 1
about 330 msec
Note: The length of low section will vary a little depending on the
conditions.
Change in output voltage of R5549 on the LD-230 board
IC1301
Procedure
1-3
ENGLISH
JAPANESE
ENGLISH
JAPANESE
Fig. 2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hdr-sr11eHdr-sr12eHdr-sr12Rmt-835

Table of Contents