Mounting Clutch Discs And Pressure Cap - KTM EXC Repair Manual

1
70
30
30
70
30
30

Mounting clutch discs and pressure cap

1
– Oil the thrust bearing
– Oil lining discs before mounting.
– Beginning with one lining disc, mount alternately 9 lining discs ( 2.70
mm / 0.10 in) and 8 intermediate discs ( 1.20 mm / 0.047 in), with
a lining disc forming the final layer upwards.
– Place pressure cap into position; fit clutch springs, spring retainer and
collar screws.
– Tighten the collar screws crosswise. Do not apply more than 6 Nm (4.5
ft.lb.) to prevent damaging of the threads in the inner clutch hub.
Mounting clutch cover
– Check whether both dowels are mounted in clutch cover or engine
housing.
– Grease kickstarter shaft seal ring and position clutch cover gasket.
Secure gasket with a little grease.
– Carefully position preassembled clutch cover and press into place,
turning crankshaft so that centrifugal timer can engage in the primary
gear.
– Fit collar screws (see sketch for screw lengths) and tighten with 8 Nm
(6 ft.lb.).
– Then check easy running of all shafts.
NOTE: If the clutch cover cannot be mounted, verify whether or not the
kickstarter spring has been positioned correctly.
70
70
M6x ...
30
30
, and slide it over the drive shaft.
30
6-6C
45