Barco RLM W12 Service Manual page 16

Motor operation command:
For motor control like lens shift, focus and zoom, the parameters + and - are defined
as follows.
Command item
focus
Zoomio
Vert.offset
horiz.offset
Lens.center
Get operations command example:
Input: op bright ? [CR]
System Response: OP BRIGHT = 100
Increase & Decrease operations command examples:
Input: op bright + [CR]
System Response: OP BRIGHT = 101
Input: op bright - [CR]
Response: OP BRIGHT = 126
Set operations command example:
Input: op bright = 127 [CR]
System Response: OP BRIGHT = 127
Execute command example:
Input: op auto.img [CR]
Response: OP AUTO.IMG
The list of valid operations commands for Barco W12 are shown in below Table.
command System Action
+ -
+ => Focus Near,
- => Focus Far
+ -
+ => Zoom out
- => Zoom in
+ -
+ => Up
- => Down
+ -
+ => Right
- => Left
(execute) Midposition shift
16 of 123