Sony SAL1680Z Service Manual page 91

4-11-2. Focus Brush Position Check (Focus Adjustment Point)
Equipment
• Personal Computer
• Finished Inspection JIG (AC100 V only)
• Lens Adjustment Program (ActuatorChecker.exe)
1. Preparations
1) Connected to equipment with checking lens. (Refer to Section 4-1-3.)
2) Start up of "ActuatorChecker.exe".
[Set up]
3) Click
2. Checking Method
[Focus Adjustment Point]
1) Click the
2) The Serial window appears. Input the lens serial number.
Note:
When
item.
Fig.4-11-9
3) The message "Move FOCUS to Near position. Then push [ENTER]." is displayed on the pop-up window.
Set the focus to the near position and press down the ENTER key.
SAL1680Z (Vario-Sonnar DT 3.5-4.5/16-80 ZA) (Vario-Sonnar T
, and perform the initial setting. (Refer to Section 4-1-4.)
.
Fig.4-11-8
[OK]
is clicked without inputting the serial number, the date executed is displayed on the completion window of each
Fig.4-11-10
DT 16-80mm F3.5-4.5 ZA)
*
4-45