Sony SAL1680Z Service Manual page 34

HELP24
Adhesive bond (B-40): J-6082-614-A
Note:
Before assembling, confirm that the rear barrel assembly moves smoothly.
After replacing the rear barrel assembly, adjust the aperture diameter.
1. Adjust by rotating the zoom cam ring so that the 4th operation plate comes in the middle (groove position at the side of outer tube) of
two small legs of outer tube.
At this moment, confirm that the narrow width lever of focus coupling barrel assy positions at the location shown in the figure.
Zoom Cam Ring
Narrow lever
Leg
2. Aligning the screw hole with the linear guide groove at the side, adjust the rear barrel assembly to reference position.
Screw Hole
Straight guide
groove
SAL1680Z (Vario-Sonnar DT 3.5-4.5/16-80 ZA) (Vario-Sonnar T
Outer Tube
4th Operation Plate
Rear Barrel Assy
Reference position
Leg
DT 16-80mm F3.5-4.5 ZA)
*
HELP