Sony SAL1680Z Service Manual page 27

HELP16
Adhesive bond (B-40): J-6082-614-A
1. Set the zoom to the tele end.
2. Set the index with red color of 1st lens holder block to the focus scale window side and push the guide bush at three locations in the
guide groove straightly.
3. Apply the adhesive bond (B-40) to the screwed portion of zoom coupling pin and tighten the zoom coupling pin.
Guide groove
HELP17
1. Align the projection of focus ring B of MF operation ring block with the pinch lever.
2. Aligning three projections of focus ring B with three cut portions of outer tube, install the focus ring B.
Then, holding its lower part by hand, turn clockwise the MF operation ring block and install it.
MF Operation Ring
Hold this portion
and turn it.
SAL1680Z (Vario-Sonnar DT 3.5-4.5/16-80 ZA) (Vario-Sonnar T
Index with red color
Zoom Coupling Pin
Cut portion of outer tube
Guide bush
Guide groove
Focus Scale Window
Apply the adhesive bond (B-40)
Pinch Lever
Projection of focus ring B
DT 16-80mm F3.5-4.5 ZA)
*
Index with
red color
HELP