HELP21
1.
Rotate fully clockwise (in the arrow direction) the focus operation ring in the outer barrel service assembly.
2.
Rotate fully clockwise (in the arrow direction) the focus lens holder in the outer tube block.
3.
Inserting the installation part of coupler in the cut portion of outer tube block, assemble the outer barrel assembly.
At this moment, insert the lever of focus operation ring in the lever groove of focus lens holder.
4.
While pushing and rotating clockwise the outer barrel assembly, tighten diagonally four screws shown in the figure.
Focus Operation Ring
Outer Barrel Service Assy
SAL1680Z (Vario-Sonnar DT 3.5-4.5/16-80 ZA) (Vario-Sonnar T
Screw
Outer Tube Block
AF coupler installing position
Focus Lens Holder
Cut Portion
DT 16-80mm F3.5-4.5 ZA)
*
HELP